• Modular interface.
• Highly optimized synth algorithmes.
• Flexible architecture: SunVox can working on variuos devices. For example: PDA with slow CPU - 16bit sound (fixed point arithmetic); or big PC with powerfull CPU: 32bit sound (floating point arithmetic).
• SunVox engine (without GUI) is open source and distributed under the terms of BSD license.
• Built-in synthesizers:
  • FM synthesizer;
  • Generator (saw,triangle,square,noise waveforms);
  • Sampler (supported formats: WAV, XI);
  • SpectraVoice (FFT-based synth for analog-like pads);
  • Kicker;
  • Stereo Delay;
  • Distortion;
  • Echo;
  • Filter (Low-pass, High-pass, Band-pass, Notch);
  • Vocal Filter;
  • Flanger;
  • LFO;
  • Loop;
  • Reverb (with DC Blocking Filter).
• Supported platforms: Windows, Linux, PalmOS, WindowsCE.
• Export to WAV.

• composing music on pocket computers or netbooks;
• embedding music into games;
• "chip tunes" creation: SunVox tunes can be very small; for example - 30 kBytes (or 2 kBytes after packing by ZIP)

• LINUX
• System requirements:
  * Pentium processor or higher;
  * 256 mb RAM or higher;
  * Any Linux distribution;
  * SDL library (version 1.2 or later);
  * ALSA.
• Unpack archive with SunVox.
• Run sunvox.
• WINDOWS
• System requirements:
  * Pentium processor or higher;
  * 256 mb RAM or higher.
• Unpack archive with SunVox.
• Run sunvox.exe
• WINDOWSCE (WINDOWS MOBILE)
• System requirements:
  * ARM CPU (200 mHz or higher).
• Copy sunvox.cab to your mobile device.
• Install it.
• Open Windows start menu -> Programs. Click on SunVox.
• PALMOS
• System requirements:
  * ARM CPU (200 mHz or higher);
  * PalmOS 5.0 or higher.
• Unpack archive with SunVox.
• Install sunvox.prc to Palm.
  WARNING. SunVox may crash some new devices like Treo 700p. In this case you must install sunvox_for_new_devices.prc instead of sunvox.prc.
  FOR T|T, T2 and ZIRE71 USERS: Please, install FHR (Fargo Heap Resizer) before SunVox running. FHR page: http://fanoush.wz.cz/palm/fhr.html
• Copy other files (examples, samples) to the flash-card.
• Run sunvox.

• C.Volume - carrier volume;
• M.Volume - modulator volume;
• Panning;
• C.Freq mul - carrier frequency multiplier;
• M.Freq mul - modulator frequency multiplier;
• M.Feedback - modulator feedback;
• C.Attack - carrier attack;
• C.Decay - carrier decay;
• C.Sustain - carrier sustain;
• C.Release - carrier release;
• M.Attack - modulator attack;
• M.Decay - modulator decay;
• M.Sustain - modulator sustain;
• M.Release - modulator release;
• M.Scaling - how modulator volume depends on note number;
• Polyphony - how many notes synthesizer can sound at one time;
• Mode:
• 00 - High Quality. Stereo. Linear interpolation of envelopes;
• 01 - High Quality. Mono. Linear interpolation of envelopes;
• 02 - Low Quality. Stereo. No interpolation;
• 03 - Low Quality. Mono. No interpolation.

• Volume;
• Type - type of waveform:
• 00 - triangle;
• 01 - rectangle;
• 02 - white noise;
• 03 - "dirty" wave;
• Panning;
• Attack;
• Release;
• Polyphony - how many notes synthesizer can sound at one time;
• Mode: HQ/HQmono;
• M.Release - modulator release;
• Sustain: 00 - OFF; 01 - ON.

• Volume;
• Panning;
• Sample interpolation: 00 - OFF; 01 - Linear;
• Volume interpolation: 00 - OFF; 01 - Linear;
• Polyphony - how many notes synthesizer can sound at one time.

• Volume;
• Panning;
• Attack;
• Release;
• Polyphony - how many notes synthesizer can sound at one time;
• Mode: HQ/HQmono/LQ/LQmono/Cubic;
• Sustain: 00 - OFF; 01 - ON;
• Sample size:
• 00 - 4096 words;
• 01 - 8192 words;
• 02 - 16384 words;
• 03 - 32768 words;
• 04 - 65536 words;
• Harmonic - number of harmonic (00 - 15);
• h.freq - harmonic's frequency;
• h.volume - harmonic's amplitude;
• h.bandwidth - harmonic's bandwidth;
• h.bandtype - harmonic's bandtype:
• 00 - half of sinus;
• 01 - square;
• 02 - organ ver.1;
• 03 - organ ver.2;
• 04 - organ ver.3;
• 05 - organ ver.4;
• 06 - sinus.

• Volume;
• Type - type of waveform: 00 - triangle; 01 - square;
• Panning;
• Attack;
• Release;
• Vol. Add - additional volume;
• Env. Accel - volume&frequency envelope acceleration;
• Polyphony - how many notes synthesizer can sound at one time;
• Anticlick: 00 - OFF; 01 - ON.

• Dry - amount of original signal in output;
• Wet - amount of delayed signal in output;
• Delay L - delay length on the left channel; maximal delay - 1/64 second;
• Delay R - delay length on the right channel; maximal delay - 1/64 second;
• Volume L - volume of the left channel;
• Volume R - volume of the right channel;
• Mono: 00 - stereo delay; 01 - mono delay;
• Inverse amplitude: 00 - OFF; 01 - ON.

• Volume;
• Type - type of distortion: 00 - limitation; 01 - saturation;
• Power;
• Bitrate: 1..16;
• Frequency: maximum = 44100 Hz (8000 in hex in pattern editor).

• Dry - amount of original signal in output;
• Wet - amount of signal with echo in output;
• Feedback;
• Delay - delay length; maximal delay - one second;
• Stereo: 00 - mono; 01 - stereo.

• Volume;
• Frequency: maximum = 14000 Hz (8000 in hex in pattern editor);
• Resonance;
• Type:
• 00 - lowpass;
• 01 - highpass;
• 02 - bandpass;
• 03 - notch;
• Response - speed of changing the frequency, resonance and volume;
• Mode:
• 00 - double sampled stereo;
• 01 - double sampled mono;
• 02 - low quality stereo;
• 03 - low quality mono;
• Impulse - frequency, that will be set immediately; after setting frequency will return to its previous value smoothly (according to value of the "Response" controller);
• Mix: minimal value - output=input; maximal value - output=filtered input.

• Volume;
• Bandwidth - bandwidth of formants;
• Amp. add - additional value for amplitude of formants;
• Formants - number of voice formants; maximum = 5 (best result);
• Vowel: A...E...I...O...U (minimal value - A; maximal - U);
• Character:
• 00 - soprano;
• 01 - alto;
• 02 - tenor;
• 03 - bass;
• Mono: 00 - Stereo; 01 - Mono.

• Dry - amount of original signal in output;
• Wet - amount of signal with echo in output;
• Feedback;
• Delay - delay length; maximal delay - 1/64 second;
• Resonance; use low values for smooth delay changing;
• Vibrato speed;
• Vibrato power;
• Vibrato type: 00 - half of sinus; 01 - sinus;
• Set vibrato phase.

• Volume;
• Type: 00 - amplitude modulation (tremolo); 01 - stereo panning modulation;
• Power;
• Frequency;
• Shape: 00 - sinus; 01 - square;
• Set phase.

• Volume;
• Delay;
• Stereo: 00 - mono; 01 - stereo;
• Repeats - number of repeats in the loop.

• Dry - amount of original signal in output;
• Wet - amount of reverberation in output;
• Feedback;
• Damp;
• Width;
• Freeze: 00 - none; 01 - freeze mode;
• Mode.

• NN - note (C0,c0,D0,d0,E0,F0,f0,G0,g0,A0,a0,B0,C1,c1,D1, ... B9)
• VV - velocity (00..80)
• SS - synth number (00,01,02,03,04,05,06,07,08,09, ... FF)
• CC - number of controller (01,02,03,04, ... FF)
• EE - standart effect:
• 01 - slide up (portamento up; sliding speed = PPPP)
• 02 - slide down (portamento down; sliding speed = PPPP)
• 03 - slide to note (sliding speed = PPPP)
• 0A - slide velocity up/down (PPPP = UUDD; UU - up speed; DD - down speed)
• 0F - set playing speed (PPPP: 0001..001F - number of ticks per line; 0020..00FF - BPM)
• PPPP - parameter of a selected effect/controller (0000 - min; 8000 - max)

NN VV SS CCEE PPPP
C3 10 03 0000 0000
-- 20 -- 0000 0000
-- 30 -- 0000 0000
-- 40 -- 0000 0000
-- 50 -- 0000 0000
-- 60 -- 0000 0000

NN VV SS CCEE PPPP
-- -- 01 0200 0000
-- -- 01 0200 1000
-- -- 01 0200 2000
-- -- 01 0200 3000
-- -- 01 0200 4000
-- -- 01 0200 5000
-- -- 01 0200 6000
-- -- 01 0200 7000
-- -- 01 0200 8000

NN VV SS CCEE PPPP
C3 80 01 0200 0000  //Set local controller 2 to value 0000. Separate sound begins playing here
-- -- 01 0200 0001  //Set local controller 2 to value 0001
-- -- 01 0200 0002  //Set local controller 2 to value 0002
-- -- 01 0200 0003  //Set local controller 2 to value 0003
-- -- 01 0200 0002  //...
-- -- 01 0200 0001

//----------------------------------------------------------------------------
width        640         //Screen width
height       480         //Screen height
fullscreen               //Set it, if you want fullscreen mode in Linux (SDL)
buffer       4096        //Sound buffer size (in samples)
audiodevice  hw:0,0	 //ALSA audio device name in Linux
frequency    44100       //Sampling frequency (minimum - 44100)
noborder                 //Set it, if you want a window without border
//----------------------------------------------------------------------------